Renogy Core 12V 100Ah Trolling Motor Lithium Iron Phosphate Battery w/ Bluetooth - 2 Batteries Renogy Core 12V 100Ah Trolling Motor Lithium Iron Phosphate Battery w/ Bluetooth
SKU: RBT12100LFP-TM-BTx2-US
- Nominal energy 1.28kWh
- Continuous discharge 150A
- Group size 24
Choose your battery pack
1 battery: 1.28kWh; 2 batteries: 2.56kWh; 4 batteries: 5.12kWh. One cart quantity means one complete selected pack. Energy is the combined nominal stored energy, not AC output. The batteries are supplied as separate units; the pack does not include a prewired battery bank.
Technical ratings, dimensions, weight and standard accessories are per individual battery unless marked as a pack total. The standard battery contents repeat for each battery in the selected pack. Interconnect cables, protection and charging equipment are separate.
100Ah lithium power for a properly matched trolling motor
The Renogy Core 12V 100Ah trolling motor LiFePO4 battery supplies 150A continuously with a 300A peak for 30 seconds. Its 12.8V nominal rating provides 1.28kWh of stored energy in a Group 24 case weighing 21.83 lb. Bluetooth monitoring lets you check battery status while planning your time on the water.

Choose the bank for your motor voltage
Choose one, two or four matching batteries. A 12V-class motor uses one appropriately matched 12.8V unit; a 24V-class system needs two matching batteries in series, and a 36V-class system needs three. Their nominal bank voltages are 25.6V and 38.4V. Confirm that the motor manufacturer permits the lithium voltage range, charge voltage and current limits before buying. Thrust pounds alone do not establish compatibility.
Plan runtime from actual current
Use the motor’s measured average draw and a return reserve. For illustration, allocating 80Ah of the 100Ah rating gives about four hours at a steady 20A or two hours at 40A. These are planning calculations, not tested runtimes: speed setting, current, wind, hull load, temperature and wiring losses change the result. This is a deep-cycle battery, not an engine-starting battery with a verified cranking rating.
Charge correctly and protect cold cells
The G2 manual specifies 14.6V charging and a 100A maximum continuous charge current. Its standard 50A procedure takes about 2.5 hours under stated conditions. Low-temperature protection cuts charging off at 32°F (0°C) or below and recovers at 41°F (5°C) or above. This model does not heat itself. Use the correct charger for the completed bank voltage, and balance matching batteries before series connection.
Fit, monitoring and expansion
The case is 10.24 × 6.61 × 8.23 in, with IP67 protection and Bluetooth monitoring through Renogy’s app. Secure it in a dry, protected location with room above terminals; IP67 is not permission to leave live terminals in bilge water. The manual supports a combined 4S4P bank of up to 20.48kWh using matching batteries. A phone app does not replace a fuse, disconnect or motor-specific breaker.
What’s in the box
Each battery includes two M8 × 1.25 × 12 mm long terminal bolts, two insulating sleeves and one manual. A charger, cables, tray, hold-down hardware, breaker and disconnect are separate. Terminal torque is 6–8 N·m; leave space for protected cable connections.
Compare capacity and plan your system
For a lighter, smaller-capacity option, compare the Core Mini 20Ah trolling-motor battery against your actual motor draw. Browse Renogy lithium batteries or use the power planner for auxiliary loads. If replacing an RV lead-acid house battery, read our lithium conversion guide to check the charging system.
Manual and warranty
The Documentation tab contains the exact G2 user manual with technical specifications and Renogy US Limited Warranty A7. Core Trolling has five-year prorated material and workmanship coverage under that policy.
| Rated Capacity | 100Ah (0.5C, 25℃) |
|---|---|
| Energy | 1,280Wh |
| Voltage Range | 10.8V to 14.6V per G2 manual |
| Maximum Continuous Charge Current | 100A |
| Maximum Continuous Discharge Current | 150A |
| Peak Discharge Current | 300A @ 30s |
| Operation Temperature Range | Charge: 32°F to 131°F / 0°C to 55°C; Discharge: -4°F to 131°F / -20°C to 55°C |
| Storage Temperature Range | 32°F to 113°F / 0°C to 45°C |
| Operation Relative Humidity | 5% to 95% |
| Dimensions (L x W x H) | 10.24 x 6.61 x 8.23 in / 260 x 168 x 209mm |
| Weight | 21.83 lbs / 9.9kg |
| Terminal Bolt Size | M8 x 1.25 x 12mm |
| Protection Rating | IP67 |
| RCM, MSDS, UN38.3, FCC, CE, PSE, IC, RoHS, UKCA | Yes |
| Manufacturer Model | RBT12100LFP-TM-BT-G2-US |
| Nominal Voltage | 12.8V |
| Cycle Life | 5000 cycles at 0.2C, 25°C and 80% DOD per G2 manual |
| Charge Voltage | 14.6V |
| Standard Charge Procedure | 50A to 14.6V, taper below 5A; approximately 2.5 hours under manual conditions |
| Group Size | BCI Group 24; verify tray and terminal clearance |
| Connection Method | Series and parallel, up to 4S4P / 20.48kWh; matching batteries required |
| Built-in Bluetooth | Yes; Renogy app monitoring |
| Self-Heating | No; low-temperature charge cut-off |
| Low-Temperature Charge Protection | Stops at or below 0°C / 32°F; recovers at or above 5°C / 41°F |
| Recommended Terminal Torque | 6 to 8 N·m / 53.1 to 70.8 in-lb |
| Material and Workmanship Warranty | 5-year prorated, subject to Renogy US Limited Warranty A7 |
| Included Battery Quantity | Selected pack: 1, 2, 4 batteries |
| Engine Starting | Deep-cycle use; no verified cranking rating |
| Pack selection | 1 battery: 1.28kWh; 2 batteries: 2.56kWh; 4 batteries: 5.12kWh |
| Pack quantity basis | One cart quantity purchases one selected pack; individual component ratings remain per unit |
| Selected variant SKU | RBT12100LFP-TM-BTx2-US |
Product reference specifications
Specifications for the selected option are shown above. These product reference details describe the listing and its available configurations.
| Rated Capacity | 100Ah (0.5C, 25℃) |
|---|---|
| Energy | 1,280Wh |
| Voltage Range | 10.8V to 14.6V per G2 manual |
| Maximum Continuous Charge Current | 100A |
| Maximum Continuous Discharge Current | 150A |
| Peak Discharge Current | 300A @ 30s |
| Operation Temperature Range | Charge: 32°F to 131°F / 0°C to 55°C; Discharge: -4°F to 131°F / -20°C to 55°C |
| Storage Temperature Range | 32°F to 113°F / 0°C to 45°C |
| Operation Relative Humidity | 5% to 95% |
| Dimensions (L x W x H) | 10.24 x 6.61 x 8.23 in / 260 x 168 x 209mm |
| Weight | 21.83 lbs / 9.9kg |
| Terminal Bolt Size | M8 x 1.25 x 12mm |
| Protection Rating | IP67 |
| RCM, MSDS, UN38.3, FCC, CE, PSE, IC, RoHS, UKCA | Yes |
| Manufacturer Model | RBT12100LFP-TM-BT-G2-US |
| Nominal Voltage | 12.8V |
| Cycle Life | 5000 cycles at 0.2C, 25°C and 80% DOD per G2 manual |
| Charge Voltage | 14.6V |
| Standard Charge Procedure | 50A to 14.6V, taper below 5A; approximately 2.5 hours under manual conditions |
| Group Size | BCI Group 24; verify tray and terminal clearance |
| Connection Method | Series and parallel, up to 4S4P / 20.48kWh; matching batteries required |
| Built-in Bluetooth | Yes; Renogy app monitoring |
| Self-Heating | No; low-temperature charge cut-off |
| Low-Temperature Charge Protection | Stops at or below 0°C / 32°F; recovers at or above 5°C / 41°F |
| Recommended Terminal Torque | 6 to 8 N·m / 53.1 to 70.8 in-lb |
| Material and Workmanship Warranty | 5-year prorated, subject to Renogy US Limited Warranty A7 |
| Included Battery Quantity | Selected pack: 1, 2, 4 batteries |
| Engine Starting | Deep-cycle use; no verified cranking rating |
| Pack selection | 1 battery: 1.28kWh; 2 batteries: 2.56kWh; 4 batteries: 5.12kWh |
| Pack quantity basis | One cart quantity purchases one selected pack; individual component ratings remain per unit |
Frequently Asked Questions
Clear answers to common questions about this product, setup, compatibility, and use.


